Laminate flooring installation is easy if you have the right tools. The key to making laminate flooring look great is choosing the right saws for the job. What is the best saw to use for laminate flooring?
A blade with a high tooth count is a must. What type of saw you use is not the most important thing. It’s also important to choose the right blade. The type of blade is just as important as the saw. Let’s find out what we can do for you.
It is not about « what is best for laminate flooring », but « what is best for laminate flooring? »
Laminate can be cut with any saw that cuts wood. You should choose a blade that has the most teeth possible.
Laminate flooring can be layered in the same way as plywood. Laminate flooring is cut in a similar fashion to plywood. Laminate flooring differs from regular plywood in that its top layer is made of hard plastic. You must pay attention to the coating as it is what chips so easily.
Straight Cuts
- Straight cuts can be made into laminate flooring using a circular saw (or rip saw), a crosscut saw (or table saw) or a chopsaw.
- A blade with more than 100 teeth per in (tpi), is recommended
- The blade that is leading the edge connects to the face of your board.
- You will need to place the board backwards if you are using a crosscut, circular, or rip saw. This will reduce the damage caused by cutting laminate upside-down. Turn the board upside-down, mark your line, and then cut. It’s less likely that the plastic coating will chip because it is not reached first. The majority of chipping occurs during the first cut of the saw. However, this is because it’s « last in the line. »
- Use a table saw or chop saw to place the laminate flooring upside down
Corner And Curved Cuts
A jigsaw is the best tool for making corner cuts and curved cuts. A bandsaw is also useful for cutting around registers.
Make sure the blade has the highest number of teeth per inch you can find at the store. It is better to buy blades made for metal cutting than those made for wood. They are more likely to have more teeth and can also be used to cut laminate.
A carbide-tipped blade is another type of blade that you can use.
Another option is to place masking tape along your cut line. Then, draw the line ON the tape again and cut the laminate. You can now remove the tape, and you will have a chip-free cut.
Once you have your laminate, make sure you do your research. You’ll be all set once you have done that.
